Select Page

Loose Tube Fiber Optic Cables

MOG

QFOI type, loose tube, copper armoured, SHF1, fire resistant IEC60331, fire retardant IEC60332-3-22 Cat.A

Up to 48 cores, tinned copper armoured, SHF1, Fire Resistant & Fire Retardant
OQFOI_1, 20.10.2020/AP rev.0
Type Approval: DNV-GL TAE00002VD 

 

 

Description

 

    

 

Store at : -40 to +70 °C
Install at : -10 to +50 °CBend minimum : 20 times O.D.
Operate at : -40 to +70 °CBend minimum : 15 times O.D.
Pull maximum : 2000N
Crush maximum : 3000N/100mm
Impact maximum : 20J
Cable weight : 240 kg/km

 

 

Design

Bare fiber : 9/125/250 Single Mode or 50/125/250 OM2, OM3, OM4, OM5 or 62.5/125/250 OM1
Buffer : Loose tube (Ø2.2mm) filled with jelly, housing up to 12 fibers
Colour code : See table
Fire protection : A fire barrier is applied over every single tube housing fibers
Central member : Steel rope with LSZH sheath
Cable core : Loose tubes and fillers (when necessary) are stranded around the central member. The core is wrapped by a tape.
Inner sheath : Black SHF1 material 1.0mm thick. Nominal outer diameter 10.1mm.
Armour :  tinned copper wire braid. Coverage ≥85%.
Outer jacket : Black SHF1 material 1.2mm thick. Nominal outer diameter 13.5mm.
Marking : APS Finland ww/mm – Fiber Optic Cable QFOI “fiber count and type” – SHF1  IEC60332-3-22 Cat.A  IEC60331-25 – lot + meter

Environmental properties and Fire Performances

Degree of acidity of gases : IEC 60754-1, IEC 60754-2 (pH value ≥ 4,3 and Conductivity ≤10µS/mm)
Halogen acid gas : IEC 60754-1, IEC 60754-2 (Halogen acid gas emission ≤ 0.5%)
Smoke Emission : IEC 61034-2, EN 50268-2 (Transmittance) ≥ 60%)
Toxicity of evolved gas : EN 50305 9.2
Flame retardant : IEC 60332-1-2
Fire retardant : IEC 60332-3-22 Cat.A
Fire resistant : IEC 60331-25 (750°C, 3 hours – 1000°C, 3 hours)
Oil resistant : intermittent splash – permanent resistance available upon request
Water penetration: IEC 60794-1-2-F5-B (loose tubes)
Water absorption: IEC60811-402 (70°C, 240hrs, increase of weight <7.5mg/cm²)
UV resistant : IEC60811-2-1, ASTM-D-2565-92A

 

Ordering and delivery information

Fiber countSMOM1OM1+OM2OM3OM4OM5Packaging
2OQFCI02S21TOQFCI02M11TOQFCI02ME1TOQFCI02M21TOQFCI02M31TOQFCI02M41TOQFCI02M51Tdrum 2000m (+/-5%)
4OQFCI04S21TOQFCI04M11TOQFOI04ME1TOQFCI04M21TOQFCI04M31TOQFCI04M41TOQFCI04M51Tdrum 2000m (+/-5%)
6OQFCI06S21TOQFCI06M11TOQFOI06ME1TOQFCI06M21TOQFCI06M31TOQFCI06M41TOQFCI06M51Tdrum 2000m (+/-5%)
8OQFCI08S21TOQFCI08M11TOQFOI08ME1TOQFCI08M21TOQFCI08M31TOQFCI08M41TOQFCI08M51Tdrum 2000m (+/-5%)
12OQFCI12S21TOQFCI12M11TOQFOI12ME1TOQFCI12M21TOQFCI12M31TOQFCI12M41TOQFCI12M51Tdrum 2000m (+/-5%)
24OQFCI24S21TOQFCI24M11TOQFOI24ME1TOQFCI24M21TOQFCI24M31TOQFCI24M41TOQFCI24M51Tdrum 2000m (+/-5%)
48OQFCI48S21TOQFCI48M11TOQFOI48ME1TOQFCI48M21TOQFCI48M31OQFCI48M41TOQFCI48M51Tdrum 2000m (+/-5%)

 

 

Colour code of fibers 

123456789101112
BlueOrangeGreenBrownGreyWhiteRed BlackYellow VioletPinkAqua

 

Colour code of tubes

123456789101112Fillers
BlueOrangeGreenBrownGreyWhiteRed BlackYellow VioletPinkAquaBlack

 

Other standards of reference

IEC 60092-370Electrical installations in ships: Guidance on the selection of cables for telecommunication and data.
DNV TAP 827.50/1Type Approval Program - Optical Fibre Cables
ABS SVRRules for building and classing. Steel Vessels.
ABS SMRRules for building and classing. Steel vessels under 90 meters.
IEC 60793General specifications for both multimode and single-mode optical fibres
IEC 60794general specifications for optical fibres cables
Every effort has been put so that this document is most reliable and free from errors. However, AP Solutions Oy cannot be considered responsible for any mistake in this document and users should consult AP Solutions Oy for any information needed. AP Solutions Oy reserves the right to make changes to the documents at any time, without prior notice.